(!)Subscribe to our channel at Zen >>IDEAS FOR LIFE| NOVATE.RU<
Bits for the screwdriver (or a screwdriver with removable nozzles) - this is one of those things that goes down very often. Each master and the owner is aware of the fact that over time, due to regular contact with screws and screws during natural labor process grinds a part of bits. Can I do something to save them? Can! Moreover, for the restoration of the bits you do not need any special tools.
need
First of all, we need a cordless screwdriver or drill, and the file on the metal. Instead of a file, you can also use sandpaper or a diamond needle file.
The essence of a subsequent process is reduced to to grind off the protrusion formed on the bit, as well as trim the "wings" of the cross. You can still grab the workplace screw head and use it to control the size.
Process
Anchoring bit in the screwdriver. The rate of speed must be set to the maximum value. Start the screwdriver and begin to grind off a file "pimpochku". It is best to take the file with a small "grain".
After that, we put the file at an angle and grind the wings of the cross. The tip is to get as before, a little dull. In no case should not be sharp. If instead of a file used sandpaper, then it is already placed on the table, and all the manipulations, we provide ourselves with screwdriver.
Continuing the theme of repair 6 ways to remove scratches from plastic surfaces in a vehicle and not only.
(!)Subscribe to our channel at Zen >>IDEAS FOR LIFE| NOVATE.RU<
A source: https://novate.ru/blogs/190718/47152/