A socket constantly falling out of the wall is not only frankly ugly, but also not very safe. Especially if we are not talking about an outlet in the far corner behind the closet and under the carpet still hanging on the wall, but about a source of electricity that is constantly used. Each person sooner or later faces the problem of a drop-down outlet, and therefore it is very important to know what should be done in such a situation.
An outlet can start to fall out of the wall for a variety of reasons. These are the mistakes of the owner or the electrician made during the first installation, and the poor quality of the product, and the improper operation of the outlet, as a result of which it was damaged. In the end, all this matters very little, since the outlet will still have to be repaired. If you do not do this on time, then sooner or later you may encounter a short circuit. In the worst case, such an outlet can burn down the whole house so that no one except Murka's cat will survive.
In a good way, the last thing to do when the outlet has just begun to stagger is to wait. The problem should be solved immediately when the first symptoms of problems appear. As usual, there are two ways to get here. Simple and to enhance self-esteem. A simple way involves calling a qualified specialist - an electrician who, for a small share, will do all the work for you in the highest class (if the specialist is good).
The second way is to try to fix the outlet on your own. It is worth resorting to it only at your own peril and risk. The first step is to de-energize the outlet. To do this, it is necessary to turn off the correct machine on the switchboard. After turning off, be sure to check the absence of electricity in the outlet using a suitable tool. And then the options begin.
>>>>Ideas for life | NOVATE.RU<<<<
Most often, the socket begins to dangle and fall out only because some screws have loosened in the mount. In such a situation, all you need to do is take a screwdriver and tighten them up. Quite often, problems arise due to the fact that the socket is not fixed in the wall. In this case, you will first have to press it all the way, and then coat the sides of the socket box with mounting glue or putty. In some cases, it may be sufficient to simply slightly squeeze the metal tabs of the socket with pliers. However, if this has been done more than once, then the mount may finally wear out. In this case, you will have to change the entire "glass" to a new one.
In continuation of the topic, read about why in the USA the socket is 110 voltsif we have 220 everywhere.
Source: https://novate.ru/blogs/060622/63209/