One of the purposes of roofing material - used as waterproofing for cut penetration of capillary moisture in the wall of the house. For this purpose, roofing material, depending on the thickness, - in one or several layers stacked on the foundation and / or basement of the building to the masonry wall of the building material. Since the wall is approximately 2 times longer than the width of roofing material, there is a need to use the cut strips.
When using a knife or saber Bulgarians as a means of cutting, tool clogged bitumen, moreover, in the process cutting generated power tool temperature at which the bitumen is melted since the melting material and the light begins to stick to the metal cutting parts.
As described below showed me a builder from Uzbekistan))). It needs only monofilament yarn or clothesline (any string that has relief)! Monofilament not applicable due to the monolithic structure and in use - without slip effect.
Everything is done in 3-4 minutes ...
Let's get started:
- Roll out the roll of roofing material over the entire length.
- Measure out the required tape width and the strip breaks the roofing made along the mark.
- In the resulting bend taken we start twine stretch and also the entire unrolled length.
- Take two thread start edge and pull with simultaneous reciprocating movements (sawn thread).
- Voila! All is ready!
Below I tried to draw on the same items!
This method is well applicable for roofing material with low density. High-density cardboard-cut is also not bad, but modified types based on advanced polymers and fiberglass do not take this way!
I hope the article has helped you and your successful building!
If you liked the post, and put Likesubscribe to my channel!