Who built in their area and the bath is often exploited her, he will inevitably face the same problem as the blockage of the chimney. Even if flushing only dry wood with a minimum resin content, sooner or later, it can be seen as diminished craving.
If the furnace system everything is in order, the reason one - the chimney is clogged soot deposits, which prevent the hot air to freely escape to the outside. Only one way out - to clean, and even at one point can be poisoned by fumes. There are three ways in which the use of your choice:
- Mechanical. Here, soot is removed by special ruff - circular brush which is pushed the chimney for cleaning deposits. The best, proven design of the ruff centuries - on the cable with the core, ie with the load, which will pull down the ruff and promote cleaned yet. Way to messy and time consuming, but loyal and reliable.
- Chemical. Carbon black - a chemical compound amenable exposed and reagents. Of course, plugging the chimney and fill in chemical solutions it nobody will. Industry produces solid and powdered funds that are poured directly into the furnace. Typically, the manufacturer recommends to heat the furnace together with the reagent. After you have for some time to shovel the ashes from the firebox.
- Thermal. If you give a strong increase of heat in the chimney, soot will start to burn through and escape. This process is the most dangerous, because soot can ignite with the emergence of an open fire. If it is a lot, a fire may occur. Therefore, heat treatment is preventive in nature and usually carried out every two or three months.
Here are instructions on how to make the ruff for the chimney with his own hands:
Step 1. Buy in-store steel twisted wire. A thin, its length should be slightly longer than the chimney channel. Second thicker and shorter.
Step 2. Take a long bolt with a washer and nut. Hold the head in a vise. Cut off grinder or cut off a piece of thick rope slightly less than the diameter of the chimney. Pliers, and a screwdriver Unbraid flat wire, and the center make a hole in weaving under the bolt diameter.
Step 3. Now raspletonnoy strung pieces of wire on the bolt, mutually crossing over them. Top, tighten the nut tightly. On the one hand weld wire - with another on the load chain. As the load you can use the anchor of an old car generator.
With such a device can be carried out mechanically cleaned without difficulty.
Other channels of the article:
7 inviolable precepts in the bath
Bath for the joints - the benefits and harms?
Helpful information? Do not forget to Like and subscribe "Bath - from A to Z"!