There are situations that we have to invent and izgolyatsya to solve a specific task. I had such a situation that I had to pull the rubber on the funnel 32. In my bathroom drainage from sinks and washing machines goes into the wall, its diameter is 32 mm. By the end of the washing machine drain waste liquid in the tube comes out of the siphon vacuum and washbasin drawn liquid, wet gate - dries and smells from the sewage can leave the tube and fill the room bath. That sometimes it happened. Just because of the discharge I disengaged kanalyuga and liquid with a smell Maleh was poured on the floor.
It was decided to establish a "aerator"
sewage aerator equalizes the pressure in the sewer pipe. It can not create a discharged pulling water from the water seal during discharge of liquid.
No problem, you can find the aerators 50 and 110 of the sewers but in this city there is not their diameter of 32 mm. Just could not pick up the distinct transitions from 32 mm to 50 mm. drain.
Therefore, the decision to pull the rubber sleeve 40h32 on 32 socket.
This procedure requires boiling. Cold cuff bad stretches. A if heated, rubber-technical product then the process will be much easier.
Pomokav our gum minute in boiling water should be immediately put on its 32 bell, pre-lubricated with silicone.
Picking up trying to pull
After finishing the procedure try on 50 aerator on the cuff. If not nalazit finalizing a file knife.
As a result, the process is complete, managed to get out of the situation and set the aerator 50 mm by 32 homemade pipe through the transition-cuff.
It remains only to establish our troynichok aerator on the sewerage system. Specifically why the case took videorolik-
Using boiling water (heating) may also be temporarily revive the valves on the valve Bochkov toilet. They again stanovjatsja soft and better take the form of flush valve seat.
I hope you have been interesting. Checkin Like at my article, so I know what is useful for you.