Sauna from chopped logs 6 * 3 meters
The bathhouse consists of two rooms - a cold dressing room (the walls are made of inch planks) and a log steam room. The foundation strip was supported by bored piles 1.5 meters long. On the territory of the steam room, under the boardwalk, an inclined screed was poured to drain water into the center and further drain it through a pipe.
For the construction of the steam room, debarked logs with a diameter of 35 cm were used. The logs were cut down using the "in the paw" technology - the protruding ends were cut off. The outer dimensions of the log house were 3 * 3 meters. Interior and exterior finishing is not provided. The walls in the steam room were not sheathed, the logs remained unpolished.
The bath floor is covered with a 5 cm planed board. Lining was taken as the final finishing of the ceiling. No insulation is provided in the dressing room. In the steam room there is a film vapor barrier on the boards, which is covered with a layer of river sand. The pitched roof was covered with galvanized corrugated board.
The dressing room and the steam room are delimited by a thick 50 mm board door. Stove-heater Rus (approximate cost - 9 thousand rubles) located in the steam room. The total building area is 15 m2. The bathhouse is used all year round thanks to a well-thought-out heating system.
The total cost of the project was 80,000 rubles.
Bath from rounded logs 5 * 8 meters
The base for the bath is the support-columnar blocks. The dimensions of one cabinet are 4 * 4 * 4 meters. Each pedestal includes 4 cement blocks 2 * 2 * 4 meters. The bathhouse project provides for one floor, the height of which is 2.25 meters. The steam room is divided into four rooms, with additional space for the terrace.
As a strapping, an edged beam of 2 * 15 meters was used (the average cost is 9 thousand rubles). For the lag of the first floor, 5 * 15 cm bars were used (the step was 60 cm). The ceiling was sheathed with imitation of chamber drying timber. For the outer walls and partitions, a rounded log 20 cm thick was taken.
The blockhouse was assembled on birch dowels, the diameter of which was 2.4 centimeters. Bars 4 * 10 cm (with a step of 1 meter) were used as a rafter structure. The subroof lathing was carried out using similar 2 * 10 cm bars in increments of up to 30 cm.
For waterproofing the space under the roof, Ondutis A insulating films were needed (average cost - 2 thousand rubles). The floor and ceiling were insulated with IZOVER 100 mm mineral wool (cost - 800 rubles).
The bathhouse has wooden windows and doors. The doors are double-glazed, the sashes are equipped with seals with fittings. The door to the steam room is made of aspen and also glazed.
The decoration in the steam room is made of aspen lining 18 * 90 mm. Foil-clad Nanoizol (800 rubles per roll) served as a thermal insulation material. A heated sauna heater "Ermak 12" is installed in the steam room.
The final cost of the project was 710,000 rubles.