The master showed how to save on heating and switch PVC windows to "winter" mode [my photos]

  • Dec 11, 2020
click fraud protection
The master showed how to save on heating and switch PVC windows to "winter" mode [my photos]

Good afternoon, dear guests and subscribers of my channel!

We moved to a new house a couple of months ago and on the nose - the first winter, which will be able to fully experience a self-assembled heating system.

As for the windows, their installation was carried out about 1.5 years ago. During this period, they were very battered during the repair: all drainage channels and seals were clogged with construction dust, plaster, etc. After washing off all the dirt, we found that half of the windows did not open / close normally, and some of them, for reasons unknown to me, had hinges sagging.

And, since the windows are still under warranty and their adjustment is included in the contract for at least 3 years in advance, I called a specialist to adjust the fittings.

It came as a surprise to me that the company would react rather quickly and the master was with me in 4 days. Having adjusted all the locks, he showed how to adjust PVC windows by pressure, which I want to share with you.

So, a change in the operating mode is nothing more than a change in the degree of adherence of the window sash to the PVC frame due to the adjusting pins. This measure allows to eliminate the draft between the frame and the sash due to the fact that in winter the rubber seal is compressed and forms a small gap.

instagram viewer

Of course, summer and winter modes are a convention, but in fact it is called adjusting the fit of the sash, just this fit is regulated by means of eccentrics. Why are 3 steps performed:

1. Location of eccentrics

We open the sash and find all the eccentrics (pins) on it.

Below in the illustration, I use arrows to indicate the places where they are located. Their number can be any, depending on the design and size of the window.

Photo source: https://4okna.info/remont/

2. Trunnion adjustment

With a hexagon, screwdriver or special. turn the eccentric key. The turn is carried out in any direction. The pivot has no stop and rotates freely around its center.

The fit check is performed after each trunnion has been rotated 45 degrees.

We changed the position of all eccentrics - checked the fit. If it is not enough, they still crank it and so on until the flap is firmly pressed against the frame.
The tightness can be fixed with a regular piece of paper.

The position of the eccentrics, depending on the modes, is as follows:

3. Check

When adjusting the fit, you will notice that the window handle will move slightly tighter due to the tighter joint.

Below in the photo, I projected the "winter" position of the eccentric when fixing the window in the locks.

From the author

If in the autumn or winter period the joint remains windproof, then there is no need for adjustment, because with a strong pressure - the seal is strongly compressed, the rubber wears out and loses its shape faster. If you feel blowing along the joint and there is discomfort among residents due to drafts or you see uneven fit in any area, it is better to adjust and slightly "tighten" the sash, then the heat loss at home will be much below.

Thank you for your attention and all the best to you!

You may be interested in:

Is it possible to increase the heat transfer of already installed radiators? - Yes (5 proven and effective ways)

How easy it is to make a warm floor if there is only radiator heating (working diagram)