(!)Subscribe to our channel at Zen >>IDEAS FOR LIFE| NOVATE.RU<
Extractor hood has long been a familiar part of any national cuisine. It helps in creating a comfortable environment, clean the air of dust, grease, combustion products, fumes, and much more. As a result, sooner or later there comes a time when you need to clean the hood, namely its bars. Care of this unit should be thorough and rigorous.
need
First of all, it will take a pan, the height of which is equal to at least half the length of the hood. It needs no longer needed a toothbrush, as well as gloves, so as not to injure your hands. Cleaned hood will be using vinegar 9 per cent, as well as the usual baking soda.
Work moment
To begin with take off our hoods unfortunate lattice in accordance with the instructions for its use. The selected pot is almost completely filled with water. We put on the fire and wait until the water boils. Adding a small amount of vinegar, about 150-200 ml (depending on the chosen volume of dishes).
Now, take a tablespoon of baking soda, and filled it to the pot. Just pour the entire soda not once, but little by little, as it will react quite actively with our "brew". When everything is ready, it can be lowered into a pot and covered with fat bloom extract grilles. The water in this case must boil. In this position, hold 15-30 minutes lattice.
After all this work fat accumulation partly delaminated. Now you need to move the lattice from the pan in the sink and pour over it a powerful water jet. Armed with a toothbrush to remove dirt residues begin.
The entire cycle described processing needs to be done with each grating twice, with each side. When that is done, the grille should be rinsed first stream of warm, then cold water spray, wipe and put to dry.
Continuing the theme yet 10 tips to help you spend significantly less on everyday needs and not only.
(!)Subscribe to our channel at Zen >>IDEAS FOR LIFE| NOVATE.RU<
A source: https://novate.ru/blogs/071218/48679/