Quite often, craftsmen and owners are faced with the fact that at the time of sawing wood with a chainsaw, its working part begins to constantly lead to the side. This is a very common problem that you can actually fix on your own. In any case, if you clearly understand why this is happening at all and is aware of what should be done in such a situation.
Why the chainsaw is pulled to the side during work
There can be two main reasons for the chainsaw being pulled to the side while cutting. The first major complex cause is wear on parts such as the saw chain and / or tool bar. Sideways can begin even if only one saw tooth is damaged. Most often this happens when, during operation, the chain hits a nail or something similar, and the tooth is deformed. In addition, in such a situation, the thrust begins to fall, which means that the master inevitably begins to press harder on the saw during work. This, in turn, leads to the development of the second problem - accelerated tire wear.
The second common cause of the described problem is much simpler and more insidious. The point is that the saw chain was not properly tensioned from the very beginning. A chain that is too tight will overheat the bar very quickly and accelerate wear. Also, in this case, the load on the tool bearings increases very much.
READ ALSO:Why does a car canister have three handles
What to do
The first and most important thing to do to ensure that the saw does not drift to the side during operation is to properly and regularly maintain it. First of all, sharpen the chain. Also, before starting work, you should check the correct tension of the chain and the condition of the tire, correct it if the sides are deformed.
>>>>Ideas for life | NOVATE.RU<<<
To fix the problem, first place the tire on a flat table and attach a square to it. This will help determine the degree of deformation. After that, with the help of a vice and a grinder, the tire rises to the level of the disc. With the help of the square, the final position is set, and the tire is re-clamped. Then it remains to process the tire several times on each side.
Continuing the topic, read about 10 incredible ways to recycle car parts and not only.
Source: https://novate.ru/blogs/081119/52346/