I recently bought a mixer in a traffic light, there is an article about this on the channel. It cost me only 639 rubles.
The complete set of this mixer is usual, a body, a watering can, a persistent nut for mounting on a sink. But unfortunately there are no water supply hoses.
I will put it instead of a simple washstand in the country. I don't install it at home, because I'm afraid of the consequences that this mixer will not withstand the pressure of the water supply. And because of him will flood the apartment.
To install the mixer, you will need to solder a combined coupling with an external thread.
No sooner said than done.
I began to try on the mixer to the hole in the street sink, I was surprised it fits into the butt, almost does not fit. We must try to get the mixer into this hole.
I twisted the hose with a little effort. I purchased the eyeliner separately.
Somehow the mixers were installed due to the narrow opening. It remains only to tighten the nut from below and connect the hose.
Tightened the nut with a wrench of 24 and moved out to open the water into the system.
Surprisingly, the mixer fulfilled its function for the money. It works in two modes, you can watch this fragment in the video.
Summing up, nothing flows smoothly, at the time of installation, but I have doubts that it will last a long time. On the water supply in the city, where the pressure can be much higher than in your garden or in the country. Therefore, I strongly advise against installing it.
, nothing flows smoothly, at the time of installation, but I have doubts that it will last a long time. On the water supply in the city, where the pressure can be much higher than in your garden or in the country. Therefore, I strongly do not recommend installing