Unread books can take revenge. This is especially well done by the Criminal Code and the instructions for the electric saw ...
Anecdote from the site: www.anekdot.ru
Hello dear readers of the channel and dear subscribers of the author's channel "Timofey Mikhailov".
I decided to share with you the information which tool I use during construction. This circular saw was bought with their own money. The manufacturer didn't pay me for advertising... Shh, what if they read me! If so, contact me, I would not mind getting paid for the review.Just a joke, I'm telling it as it is.
I am building a "house - bath" from aerated concrete 12 by 8, from the easiest material to master for self-builders.
Now I have begun to install the last row of gas blocks, it will be reinforced with concrete. To do this, make a groove in the block 10 cm wide and 10 cm deep. I took the very minimum parameters. Since there will be no second floor, the roof will immediately rest on it. According to calculations, in plan
"it will fit", just such an armo-belt was chosen.After scouring the Internet, I found a way to quickly cut a block using a circular saw. Since I do not have a circular saw, then we will buy. An important selection criterion was the depth of cut and the price for this product. I got this device:
The usual circular with which the market is crammed head over heels. But, in terms of price and cutting depth, it has no equal in this segment. Moreover, a saw blade was included with it. And this is savings, at least 800 rubles.
Naturally, the first thing I decided to do was to check his work on sawing boards into bars. It turned out not bad. What can we say. The saw is new and the disc too.
If this circular survives after aerated concrete blocks, then later I will use it for its intended purpose.
The gas block is a pliable material in processing, therefore, at least at first, a disk with victorious nozzles should cope with cutting this material without any problems. And so it happened.
When working with this device, I did not experience any discomfort, the engine did not choke, the gearbox did not overheat. The construction itself is solid. Smooth start and saw precision. You can look at the full characteristics at Yandex-Market. As well as the prices for it. Choose with the lowest price.
By the way, prices for it fell ...
Disadvantages:
Quite heavy (8 kg), clumsy design, could not lower the disc below 80mm (cutting depth).
As a result, at the time of testing, he copes with a very dusty job. And when he has cut through 120 meters of dusty aerated concrete and does not break, then I will disassemble and clean it. There will be an article about this on the channel. Subscribe.
Here link on my author's channel, most likely useful information awaits you there: From SW. Timofey Mikhailov.