Content
-
1 Cooker hoods
- 1.1 Device
- 1.2 Hood selection
- 2 Conclusion
Now, in almost any kitchen where a little bit of a decent repair has been made, a device for drawing in air hangs over the gas stove, but this does not always help to keep it clean. So, which hood to choose for the kitchen, so that it fulfills its function, and not just serves as a dubious decorative ornament or just an attribute of the room?
Kitchen hoods must match their purpose.
Cooker hoods
Device
Schematic diagram of a kitchen hood
- To figure out which hood to choose for the kitchen, you need to understand how it works, that is, how it cleans the air, because this is its main and only function. On the right side of the diagram, the voltage for powering the module is indicated - 220V, that is, identical to the home network. The following shows how the engine is started using a starting capacitor (there may be one, but maybe several) with blades, which actually pumps air from the apartment into the pipe, or hood.
- As a rule, modern hoods have several positions for switching the engine rotation speed - there are three of them on the diagram (there may be more, or maybe less). Also, the module has a built-in lighting with a switch, powered by the same line as the engine. Upon purchase, an instruction is attached to the device, which describes the power and capabilities of the device.
- The main parameters of the exhaust mechanism, which you should be guided by when buying, are its capacity, configuration and, of course, price. Such a device should be purchased either after purchase or at the same time as the purchase of a kitchen unit, so that you had the opportunity to position the mechanism just above the stove, and so that it would fit into the interior of the room.
Read also the article “How to connect a hood in the kitchen - the rules of the installation process”.
Hood selection
The hood design is not the least important
- When you think about which hood to choose in terms of power, this is not entirely relevant at this time - almost all kitchens are the same and the device is also equipped with a speed controller of the impeller rotation, in addition, you can buy a device with two motors. So the power, most likely, will be enough for you, but it may be that you turn on the twin-engine hood at the third speed, and the effect is almost not felt. What's going on?
- In order for the hood to suck in air, for this it is necessary to create conditions for it, because this is not a vacuum pump and it cannot pump out air from the room, even the most powerful one. This means that in order to create the possibility of air outflow, it is necessary to provide a channel for its inflow, that is, open the window at least to the position of the microclimate.
Island hood for kitchen
- So, the choice of a kitchen hood should be focused on its integration into the interior, and it will draw air in any case, if conditions are created for this. But it is not always convenient to open a window to the street, because in most cases this means an influx of dust.
Mortise supply valve (VPK)
- And what to do if your windows overlook a busy dusty street and there is practically no way to open the window? Everything is very simple - you install the inlet inlet valve with your own hands (see. photo above), and air exchange will be provided for you! At the same time, street dust and insects will not get into the room, since the MIC is provided with a filter.
Kitchen hood with filter requires regular maintenance
- Also, if we choose a hood for the kitchen, then we can stop at the unit with a filter for air purification, that is, in fact, it is the distillation device and the air in the room does not change, like an air conditioner that passes all the air through itself to cooling. But such a hood requires regular filter changes (once or twice a year) and creates a lot of noise.
- On the filter of the hood, the smallest pieces of food are deposited, thrown out in vapors from pots and pans, but, nevertheless, this is not a gas mask and the smell will still remain. If you are interested in clean air, then the room needs to be ventilated, which cannot be achieved with the help of the above device.
- What is the conclusion if the air does not need to be filtered, but simply replaced? Yes, of course, the hood should extract this air and throw it out into the street, and fresh air can enter the room, again, only from the street. This means that the best option is an exhaust hood that promotes complete air exchange in the room.
- In the entire article, there was never a mention of any company that produces hoods, and this is no accident. The fact is that, as you yourself have seen, such a device is quite simple and eminent manufacturers to a greater extent take money for the brand, and you yourself can choose it. But this does not mean at all that the cheapest product will suit you, because quality is also paid for, and the price will also depend on the configuration (number of speeds, engines and material).
Advice. For lovers of silence, the choice of a hood for the kitchen may be to select a duct fan that can be mounted directly into the air duct. The volume of the device is also affected by the shape of the channel section - a round pipe creates less noise, because the flow does not twist in the corners. In order not to create unnecessary trouble for yourself when caring for your hood, choose a stainless steel model. Such a surface is easy to clean and does not lose its attractive appearance.
Which hood for the kitchen is better - see here.
Conclusion
Watch the video clip located here and think about exactly what you expect from your hood.
Do not forget to consult with the seller, perhaps he will tell you a more suitable model for the volume of your kitchen and your existing needs.
Also, when buying, you should focus on the size of your gas or electric stove.
Read also the article "How to make a hood in the kitchen: step by step instructions".
Gallery
