How to clean a cooker hood in the kitchen with your own hands: instructions, photos and video tutorials

Cleaning a cooker hood is a rather complicated and time-consuming process. However, many people have to deal with it, because the hood is a device that gets dirty quite quickly. Cleaning the filter is usually particularly difficult.

As a result of constant exposure to various vapors, the hood becomes dirty quite quickly.

However, despite all the difficulties of this procedure, it must be performed, otherwise the efficiency of the hood will be significantly reduced.

This is due to the fact that, as a result of clogging, the filters begin to pass much less air through their holes, as a result of which the circulation of air flows becomes less.

Before you wash the kitchen hood filter from grease, you should stock up on detergents, rags, and most importantly, patience.

We start cleaning

First, you need to get the filter and assess the degree of contamination. Of course, if the hood is new, it will be very easy to clean it. To do this, you just need to rinse in hot water with a cleaning agent.

The filter is generally round for easy cleaning

The situation is much more complicated in cases where the device is quite old. Many people wonder how to clean a kitchen range hood that is several years old.

There may be several options here.

Simplest method

• If the filter is not too dirty, the simplest cleaning method can be used. In particular, before cleaning the hood in the kitchen, it is necessary to place the filter in hot water and detergent.
• After the contaminated element has been soaked in water for some time, it is necessary to evaluate the effectiveness of the measures taken. If, after thoroughly cleaning with your own hands, the filter remains as dirty, it is time to move on to more drastic measures.

Drastic measures

• In the event that the above measures did not give the desired result, you can resort to a little trick. Before you wash the hood in the kitchen, you need to collect water in a large pot, put soap (preferably household soap) in it and add a few tablespoons of soda.

It takes a lot of effort to keep the filter so clean.

Tip: if the filter does not fit in the container, then you can boil it in parts, that is, first one side, then the other.

• You need to boil for 5-10 minutes, after which the filter should be left in the solution for several hours. Such a measure must be carried out with all parties.
• This kind of cleaning of the hood in the kitchen allows you to remove serious layers of fat. However, it does not always carry the proper level of efficiency. Sometimes you have to resort to other methods.

Read also the article “How to choose a hood for the kitchen: the question on which the air purity depends”

More drastic measures

If you have no idea how to remove grease from the hood in the kitchen, which cannot be washed with the usual methods, you have at least two ways out.

First, you can do the following:

1. Spray the filter with gutter cleaner.
2. If you have a stainless steel sink, you can fill it with water and add cleaning agent. In this case, the instructions for the purchased substance must be previously read, since not everything can be used in hot water. There are samples that can only be used at low temperatures.

Perhaps the most well-known remedy today is the "Mole" familiar from childhood

1. Put on rubber gloves, then carefully lower the filter into the prepared solution.

1. Later 5-10 minutes there will be no trace of fat.

This technique allows you to very effectively cleanse fat formations.

However, it should not be used too often, as alkaline substances can destroy the metal structure of the filter. In this regard, there is a need for a more gentle method.

It is possible to clean the filter using drain pipe flushing agents, the price of which does not exceed 250 rubles.

To do this, you need to do the following:

1. Place the filter in a baking sheet.
2. Sprinkle it with a cleaning agent (in most cases it is sold in granular form).
3. Sprinkle gently with hot water. As a result, a violent chemical reaction should appear.
4. Hold the filter in this position for 10 minutes.
5. Drain the solution as carefully as possible into the toilet.
6. Rinse the mesh.

This photo shows how effective filter cleaning is.

Cleaning the hood itself

That's it, the filter shines and shines. Next, you need to clean directly the hood itself. To do this, use a special cleaning agent for stainless steel surfaces.

Tip: in order not to leave streaks, you should wipe the steel along.

If such a product is not available (or the hood is not stainless steel), then there is an alternative method.

Dilute 1 teaspoon of dish detergent (eg Fairy) in a liter of hot water. This solution is required to rinse the entire surface of the hood.

Read also the article “Choosing a filter for a kitchen hood”.

Recommendations for use

Now it's time to publish some useful tips that will significantly increase the operating period of the device:

1. A qualified specialist should install the equipment, since its service life depends on it. However, you can do this yourself if you watch the training video at the end of this article.
2. Never leave the gas on when there is no cookware on the stove. Direct fire can melt the plastic parts of the hood.
3. The hood can only be cleaned when it is disconnected from the electrical network.
4. The filter should be cleaned at least once every 2 months.

Using this table, you can choose the appropriate size of the hood, in relation to the area and height of the kitchen

Conclusion

In this article, several ways were discussed on how to clean the hood in the kitchen.

Depending on the level of contamination, you will need to choose the most suitable option, while not forgetting the precautions.

It is very dangerous to wash old filters with alkaline solutions, as they seriously destroy metal coatings.

Italian cooker hoods - see here.