With the construction of the bath used a variety of materials, but the most popular is still regarded as a tree. Today let's talk more about how to cost-effectively build a sauna from a bar, as well as how much material you need to buy for a bath 4x4.
- The walls of the timber stacked much faster and easier than conventional logs. In addition, it should be noted that the frame can be installed on a prepared foundation.
It is important! When using timber in the construction of a bath, you will significantly save your family budget. This is due to the fact that you can deal with the construction of their own, without the aid of expensive specialists.
- Prefer material of larch, the material will serve you for many years without a hint of decay. Because the material is quite expensive, you can only use it in the construction of the first tier.
- Further, we recommend that you use any of conifers. Due to the fact that in their composition have resin, the material is perfectly cope with water-repellent task.
- Boxes with the bar sold in the optimal size for the construction - 150 to 150 mm. For necessary processing wood using conventional motor oil.
How to build a sauna from a bar 4x4
Many experts say that the bath is necessary to build one of the following ways:
- Strip foundation. In this case, the concrete is poured directly into the ground around the perimeter of the future building.
- Pier foundation. The entire perimeter of the future bath set and fixed columns of bricks. It should be noted that each column should be strengthened concrete solution.
Assembling walls bath 4x4
- Not tightly fill the space between the boards of a special seal.
- Pre-calculate the necessary amount of timber on the basis of your project. It is better to do it with a reserve for contingencies.
- Use templates for the production of the necessary length of the rod. Prepare several products to facilitate his work.
- To secure the boards to each other, it is necessary to adjust it to the selected location, and then drill a hole through each 1.5 cm. However, we should bear in mind that you should not be completely drilled beams, but only half.
- After that, remove the last bar and the hole are driving a special peg of wood, which can be purchased at any specialized shop. After installation, carefully check the boards at density.
bath 4x4 doors should be installed on a special binding that should be installed above floor level. Windows are installed on the same principles. Do not forget that you need to leave a small gap to fill it later seal. Shrinkage occurs as a rule, for 7 months, Finishing work begins only after the elapsed time.
Now you know that self-built bath in the cellar and do not take much time.