How to make a smoke sauna with their hands

  • Dec 24, 2019
click fraud protection

To begin production of smoke sauna if you have a project, it should be a foundation. Parallel ordered framework. To chop down a bath no no special requirements, it can be made from any wood, even conifers or from a bar. It is important in laying the bath not violate building codes: observe fire distance from other buildings.

To make a strip foundation, dig around the perimeter, on the basis of log sizes, ditch depth of 60 centimeters, Is filled with sand and gravel, put the valve and poured cement mortar. Be sure to do the waterproofing by laying two layers of roofing material using bitumen. On the lateral surface of the foundation it is desirable to make holes for ventilation basement.

For light baths are successfully used and other types of foundations - pile, columnar, tiled. There are baths altogether without foundation, if the soil is rocky.

Second phase - foundation device for the furnace. It is similar in design to the building foundation. It is believed that a bath of the washing compartment

instagram viewer
10-12 square meters meter size is sufficient stoves per meter. Then do the floors. Most often make wood floors, stacking boards on the support joists. Sometimes make a cement screed floor and trim the rough tile.

Install frame. Typically, in the bath in the smoke flue and no windows. Box set only in auxiliary premises - for example, in the common room, if any project.

Be sure to arrange the high threshold in the washing compartment - because all the heat in such a bath is going to the bottom. The ceiling in the steam room for the same reason, make low. You should not seal the timber walls in the steam room, as through the gap at the furnace bath should emit smoke.

The furnace stack of stone or brick, it is inserted into the boiler, where the water will be heated. The roof is built in the usual way - arrange the ceiling, making the rafters and roof. Ceiling necessarily made of hardwood, as conifers by heating the resin was isolated. Hot resin flowing down from the ceiling, can be badly burned.

It should consider how to bath water will be supplied, either bring electricity, or to drill the well, or to provide the possibility to bring the water in the buckets from the well or from the column. Electricity, if you want it, stretch the air way.

The last stage of doing the final finish, a relaxation room sheathe inside wooden paneling. Use plastic is not recommended, because when heated it releases toxic substances. Finally, the imported equipment, furniture, firewood. It is strongly recommended that you purchase a large fire extinguisher.

Other channels of the article:

7 inviolable precepts in the bath

Bath for the joints - the benefits and harms?

Helpful information? Do not forget to Like and subscribe "Bath - from A to Z"!