Good afternoon, dear guests and subscribers of the "Build for Myself" channel!
I confess that I myself have never been in similar situations and in other houses I see a lot of similar moments when people go down or go up the walls wires snot to the nearest outlet and the reason for this is ill-conceived wiring. And, what is even sadder, the wiring was carried out according to projects in which the necessary electrical points are simply forgotten.
And, in this article, I would like to warn people who do not have much experience behind them - they are in the process of installation or are just going to perform the electrical wiring.
If you don't think about all the electrical appliances in the house in advance, then later, we will definitely get a bunch of wires hanging down the walls and a lot of sockets occupied by tees.
So, household appliances that are often left without power:
On the kitchen
Hood, electric oven ignition, dishwasher
If appliances such as a dishwasher or oven with an electric ignition function can be powered from an outlet the refrigerator and the wire to stretch behind the kitchen cabinets or in the baseboard of the countertop, then you will have to tight.
Without power at the top point, connecting the hood (or split system) will have to "farm" and run the cable down the wall to the nearest outlet.
In the bathroom
Forced ventilation, mirror lighting, heated towel rail
It is often forgotten to leave the power cord under the auxiliary lighting in the bathroom, but in reality this is not a trifle. Hanging a mirror with lighting or additional lighting near the sink, we are forced to connect them to one single outlet in the bathroom.
If there is no sufficient ventilation of the bathroom, then you cannot do without forced ventilation. And, here the story repeats itself: the fan electric motor requires power and we release cable sniff to the outlet.
Many people remove water-dependent heated towel rails and plug in electrical products. You need to provide a separate outlet for such things in advance.
The corridor
Security / alarm unit and video recorder
A very common mistake when people do not leave power wires from the walls or separate sockets for security systems and video surveillance equipment. As a result, these systems occupy only two sockets, which are located in the corridor, and there are no places even for charging the phone.
From the author
It is better to think it over seven times and complete the installation once, otherwise a bunch of wires will go in cable channels, near the baseboards and behind furniture, which does not look aesthetically pleasing at all.
I hope this article was useful to you. Thanks for attention!
Read also:
I learned that all natural stone is phonite. Checking the radiation level of my house
How do you know how much the house was out of light during your vacation?
How to make a comfortable toilet? Indentation not according to norms, but according to the mind