How to seal the hole in the particle board quickly and easily: a visual guide

  • Dec 24, 2019
click fraud protection

(!)Subscribe to our channel at Zen >>IDEAS FOR LIFE| NOVATE.RU<

What to do if the board chipboard hole appeared? In fact, even such a serious problem can be easily and quickly solve their own hands. Enough to get some supplies and an hour or two to work with his hands. Cope with such a repair task is actually even a child.

Need glue and sawdust.
Need glue and sawdust.

In order to seal a hole will need PVA glue, sawdust (not the smallest), oil, long wood screws and a thin wire. You also need to purchase a short wood screws, two smooth fiberboard sheet, each the size of a hole. Still it is necessary to obtain a large sandpaper on wood, self-adhesive wallpaper the color of the furniture and wood file. That's all that we will need to emphasize Novate.ru consultants

Make a slurry.
Make a slurry.

Take a few handfuls of sawdust and put in a container, fill them with white glue. Pour a little less than it was poured sawdust. A good mix. The resulting mass should not unravel or break up. If this occurs, add more sawdust at the sprawling and more glue in disintegration. When the mixture is ready, give her 10-15 minutes.

instagram viewer
It is important that the substance was the right consistency.
It is important that the substance was the right consistency.

While the mixture is being prepared, working with the edges of the holes. We break off all protruding lumps, and we clean the surface. After that screws are screwed into long Dig inside edge and connect them to the wire, having a kind of reinforcement. The ends of breaking grease with white glue.

We do reinforcement.
We do reinforcement.

Take maximally flat surface (e.g., fiberboard sheet) and fasten it to the short screws with one hand of breakdown. Now is the time to lay sticky mass into the breach. It is necessary to lay so much that it is a few millimeters thicker than the base sheet.

Close the back side.
Close the back side.

When done, put on top of the mass of another sheet coated with adhesive and fiberboard presses him with something heavy. Leave for a couple of hours. After this will only clean the surface and stick the appropriate wallpaper.

Put the pulp and cover.
Put the pulp and cover.

Continuing the theme rework the idea of ​​rusty iron baths from the legendary film "Breakfast at Tiffany's" and not only.

(!)Subscribe to our channel at Zen >>IDEAS FOR LIFE| NOVATE.RU<
A source: https://novate.ru/blogs/131218/48754/