(!)Subscribe to our channel at Zen >>IDEAS FOR LIFE| NOVATE.RU<
There can be a situation that the water pipe is necessary to cut the thread. Make it really is not difficult. Expensive and rare instruments do not need to perform this task, and the procedure is not very complex, so that even a beginner will cope if it has the slightest idea of working process.
What is needed
In order to cut into the pipe thread need not too many things. Primarily this die stock under the desired pipe diameter. Also, we need to be adjustable (gas) key. That's all that is needed, but the desire and hands.
Need is such a thing.
One need only recall that the die stock - a thread cutting tool in which the nozzle has a guide skirt. You can purchase it in sanitary shop. Deficit on a similar tool No. There is such in the area of 200-500 Russian rubles. Running models are designed for 1/2 and 3/4 inch.
The working process
Lubricates the place on the pipe, which will be carved. For this we use the engine oil, grease or litol. Promazyvayut cutters on the tube. Many do not need to apply grease. Old paint can not be removed.
Now we put on the die stock guide pipe. To work there is a special tool - ratchet, but since in this case the work (most likely) be a one-time, you will acquire the tooling is not highly profitable. Adjustable wrench to fit the rear skirt die stock. After doing this a few cautious speed, appeared to cutters. If the pipe is shaky, it is possible to hold the second key.
cutting sequence is as follows: 2-3 die stock turn forward 1 turn back. If we ignore the technology, there is a risk that the chips zamnet the threads. All you need to make 4-5 complete turns.
I want even more interesting? How about finding out about these 10 mysterious artifacts that have been found in the Nile Valley recently.
(!)Subscribe to our channel at Zen >>IDEAS FOR LIFE| NOVATE.RU<
A source: https://novate.ru/blogs/200718/47167/