Dilema: Glue foam or adhesive solution. What to put the gas block on. I'll tell you what I chose. Personal experience # 20

  • May 05, 2021
click fraud protection

Before building a house, a bathhouse, any capital structure made of gas-filled silicate concrete, I recommend watching Gleb Green's videos. And on the basis of the knowledge gained, make decisions on what and how to work when laying gas blocks in "even rows".

Dilema: Glue foam or adhesive solution. What to put the gas block on. I'll tell you what I chose. Personal experience # 20

During the construction of his House-Bath, the question arose: Put blocks on Special glue or apply "Foam-cement"?

Dilema: Glue foam or adhesive solution. What to put the gas block on. I'll tell you what I chose. Personal experience # 20

Before you understand what I have come to, you need to know what is given to me:

It is necessary to fit 28 cubic meters of the block. I work alone. The blocks are relatively flat.

  • In my opinion, in order to work with a special mineral glue, you will need to be distracted by its preparation. The work is quite dirty, no matter how hard you try, gray spots will be on the walls. Which is not very good in the absence of timely exterior decoration. Vertical seams are difficult to make thinly sutured, which is why some bricklayers do not even fill them.
  • When working with special glue-foam, you do not need to prepare a solution. It is only important to keep the cylinders warm. It is applied to previously dust-free blocks easily, without problems. But, you need to understand that the seam is less than a millimeter, so there is a very large requirement for the block geometry. And if they jump in size. You will have to erase a lot of graters on the gas block and spend a lot of time.
    instagram viewer

In the end, I chose foam glue for the construction of a large bath. Looking ahead, I'll tell you. After laying 28 cubes of this building material on a solution from a spray can, I began to understand that in the future, if it is necessary to build from "gas", then I will "put" on horizontal seams on mineral glue. And the vertical seams, I'll fill the glue with foam.

This is the twentieth article in this series. In this series, information awaits you: what material for construction I stopped on, how the shallow foundation was poured, why the wall cracked and how the roof rose and many others solutions. Not entirely correct. Learn from my mistakes. Don't let your own. Subscribe . Articles are published every day at 8 am Moscow time. You can also click on the tag below "Timofey's bathhouse".