(!)Subscribe to our channel at Zen >>IDEAS FOR LIFE| NOVATE.RU<<
Probably, many faced with the disgusting situation, when the light bulb burned out at the most inopportune moment. Worse may be only one: if this is still stuck in the cartridge. What to do? To begin with, settle down and run for... scotch tape. No, not as an alcoholic sedation. But without the adhesive tape you can not do.
Step 1: Always turn off the light
Ideally, the best cork is also transferred to the mode "off". Wait at least 2 minutes for the lamp to cool sufficiently before proceeding to further action.
Step 2: tape
Cut fragment wide adhesive tape, about 60 cm long. Gently connect the ends of the ribbon together to get the ring. Gently: different parts of the tape, and so will norovit stick together with each other.
Step 3: "Lasso"
Carefully place a ring of adhesive tape around the jammed bulb. On both sides, connect the ends of the adhesive tape to each other, as shown in the photo. This is - your "levers".
(!)Subscribe to our channel at Zen >>IDEAS FOR LIFE| NOVATE.RU<<
Step 4: Turn the
Slowly, clockwise turn the tape with a light bulb inside, holding both the "lever" the thumb and index finger.
Done!
But not everything can go smoothly. For example, the lamp may break or you pull it, but cap will remain in the cartridge. If the preceding step did not have to do without the tape, but now it was the turn... cola! More precisely, an empty plastic bottle of fizzy drink.
Take a plastic bottle, unscrew the cap and heat the neck over a fire lighter until the plastic will not melt. Do not forget that the light should still be turned off.
Take the bottle and insert it straight into the neck of a cartridge with a cap stuck. Wait a bit to cool down the plastic, and gently turning the bottle, remove it together with the jammed piece.
(!)Subscribe to our channel at Zen >>IDEAS FOR LIFE| NOVATE.RU<<
More information at our website: Novate.ru novate.ru/blogs/180716/37264/