Good day, dear readers!
In this article, I will share how to make the installation of a bypass chimney of the boiler to the main shaft for flue gas.
Since the basic configuration the boiler is equipped with an adapter to go to different systems smoke, I decided to purchase a separate adapter with native buderusovsky DN60 / 100 to DN80 with air intake from the premises.
Why is the room? Trite, but in reality there is no place on the front of the building, because of this border passes a gas pipe vertical riser.
Further, the boiler hung on the center shaft, and made a stopped - for the purchase of additional tubes.
As a result, with the adapter purchased elbow 90 °, 0.5 meter tube. - 80 mm. and an inner transition connector ( "mom / mom").
Both elements (the connector and adapter) is put on the seats and measured distance to trim the size of the riser.
Measurements removed and cut tube.
After cutting, it was necessary to clean and chamfer edge of the pipe, since the connection is made through rubber seals.
Next, the entire structure assembled and put on one end of the shaft sleeve in brick, other - at the boiler outlet.
Then set the throttle aperture and pulled screws, come with the adapter.
Chimney ready, and you can further customize the turbine boiler.
Thank you and good luck with your repair!
See also my article "As I ran two days of the boiler. Riddle from the manufacturer "
____________________________
If you like, place the Like andsubscribe to my channel!