Last spring, I found the room lighting control system Noolite new keyboards RADIO.
I had two switches - one-button and dvuhklavishny. For convenience, I put one-button switch in place of regular switch at the door, and dvuhklavishny switch over the bed, so that you can turn on and turn off the light in the room, not getting out of bed.
The first key switch dvuhklavishnogo just duplicate the main switch (short keypress up includes light, short pressing down off the light, long press up and down increases and decreases brightness). The second key is remained unused, and I've been going to use it by assigning it to the preset minimum and maximum brightness level.
Yesterday, I finally figured out the switch in programming and everything set up.
We have Noolite scenario - in fact it is stored status light. In other lighting control systems are usually referred to as presets. Can be programmed to a certain key, any state lighting, such as "light off", "light is turned on at full brightness," "light is included in the determination of the brightness, "in this case, if the actuators are many, scenarios can control multiple light sources at the same time.
It turned out that the switch can operate in four modes, but such that one key to control the light, as usual, while the other scenarios, no. I used the mode when the two keys control the four scenarios and did this:
Left button up - lights on at full brightness.
Left button down - turning off lights.
Right key Up - 50% brightness.
Right button down - for a minimum of brightness.
The disadvantage in this control method, only one - can not set an arbitrary brightness. But this is not a problem - in fact, this additional switch over the bed, and on the main power switch at the door, you can install any brightness.
Programmed it all follows. In mode, the system considers the scenarios each position of each key separate switch, and each of them need to bind to the effector unit. Dvuhklavishny switch to normal mode, the system considers the other two separate switches.
When you first switch binding, you need to press a button on the actuator, but when at least one switch is attached, to climb up to the ceiling and shoot the chandelier to push the button is not required.
The back of the switch have privzyaki button and two dip switch selection mode.
binding procedure switch in script mode when the switch is already bound in the normal mode, as follows:
1. Microswitches set normal mode.
2. Push the button, and then press the switch. Light flashes, indicating entry into a binding mode.
3. Toggle switches, turning the switch to the four scenarios mode.
4. Again, press the button and the desired key.
5. Repeatedly press the button and button.
The first scenario is attached. Repeat steps 1-5 three more times for the other three scenarios.
At first glance, all this seems complicated, but it is necessary to do a binding once, everything becomes simple and clear.
Memorized script is very simple: switch normally set to the proper state of light (Off, it is turned on, is set to a certain luminance), and then pressed and held desired scenic button. Pressing this button will now establish the lighting in the stored mode.
Very convenient, now lying on the bed, you can not just turn on and turn off the lights, but also fast to install (or enable) it at low or medium brightness.
p.s. So far, I have a light control system Noolite is only in the living room. In theory, you could install it on all apartment and do, for example, buttons with scripts "turn off the lights throughout the apartment," or "Turn on the lights for the night going to the toilet," turn on the light in the hallway and a closet on the lowest brightness, while placing the switch room.
© 2016 Alex Nadozhin
The main theme of my blog - Equipment for human life. I write reviews, share experiences, talk about all sorts of interesting things. And I'm doing stories of the interesting places and tell about interesting events.
Add me to your friend list here. Remember the short address of my blog: Blog1.rf and Blog1rf.ru.
My second project - lamptest.ru. I test LED lamps and help figure out which ones are good and which are not.