Greetings to all subscribers and visitors to the channel. We continue to share all sorts of tricks with those who decided on their own to master the manual arc welding. Welding inverter requires that it be cleaned regularly (purged) from dust, for long and trouble-free operation. Today I'll show you the easiest way to do it.
This morning I decided to sweep the area in front of his garage, where I work. So decided at the same time, just I went struggle for the purity, blow your welding inverter. Usually I do this torch-cutting open the valve, and a jet of oxygen under the pressure of all that I do. But I have an oxygen tank is empty, and the new yet not made up, so we'll do it a little grinder!
With grinders remove the handle and all the nuts under the wheels, removing the cover is not necessary, it does not hurt us, and it is long.
All Bulgarians have a ventilation system and the air passes through the inner jet grinders blown a good through here are holes in the gear housing. But the stream of air is not quite right out of these holes, and at a certain angle, which can be determined by substituting his hand under the stream. It is necessary to know in order to direct the jet with maximum effect.
Unscrew the metal casing of the inverter, and saw that all the insides of my welding in a decent layer of dust. Turn on the grinder, and begin purging the insides of the inverter.
That such effect was from the cooling jet small grinders! In my opinion very good.
Even if it does not stream from the compressor, but look like a bunch swept screws that secure the metal casing of the inverter. For fun, I sent a jet of air to the pile, and the result speaks for itself.
So that this method is very simple and work when other options to purge their welding dust there. We put all the pieces in place grinders, spin screws, and start to work.