2 correct ways to close the gap between the bathtub and the wall, so as not to flood the floor and someone from the bottom

  • Dec 24, 2019
click fraud protection
The gap between the bathtub and the wall.
The gap between the bathtub and the wall.

When the wall between the bathroom and the gap appears, then after a while it can become the cause of many problems. First of all we are talking about flooding and mold growth, which inevitably will. It is therefore very important time to get rid of this problem. The two most popular and best ways.

Method one: use sealant

 A quick way to solve the problem. / Photo: ogodom.ru.
A quick way to solve the problem. / Photo: ogodom.ru.

The simplest and most obvious thing you can do with a hole between the bathroom and the wall - is to remove it with a sealant. The first step is to clear the work surface (clean bath skirting and the wall itself). For this we first use plain water, and then degreasing composition itself dry them thoroughly.

>>>>Ideas for life | NOVATE.RU<<<<

Can be repaired and the sink immediately. / Photo: prorab.help.
Can be repaired and the sink immediately. / Photo: prorab.help.

After that, install the cartridge into the gun. Remember that the hole should be always larger in diameter than the gap that should be hidden. Start insulation is best over the edge. Dispense sealant so that he would lie as uniformly as possible. The resulting roller should be carefully spread spatula and align with work surfaces. Before starting work, it is recommended to moisten the blade with a soap solution.

instagram viewer

Now you just wait until the solution has dried. When this happens, you should remove it surplus.

Method two: Use ceramic border

Models with the area look nicer. / Photo: stroi-specialist.ru.
Models with the area look nicer. / Photo: stroi-specialist.ru.

The best way to solve the problem with a gap between the wall and the bathroom was used ceramic frieze. This material differs from plastic enhanced reliability and durability. It does not change the shape and tone over time, it does not react to acid and alkali.

Beautifully and succinctly. / Photo: yandex.ru.
Beautifully and succinctly. / Photo: yandex.ru.

Installation work start with surface treatment with the solvent. When it dries, all the cracks are filled with sealant. When this is done, put the ceramic area. It was from him glued all the other elements of the ceramic border. Make every effort to obtain a flat surface.

When you get to a second corner, you will need to cut the excess length curb. This can be done using the grinder. Do not forget in this case Feather edges. When the entire installation is complete, you should wipe the seams with sealant and grout for a tile. In the final step is to remove any excess material.

>>>>Ideas for life | NOVATE.RU<<<<

Continuing the theme 10 solutions for the bathroom, which are suitable even for small spaces and not only.
A source:
https://novate.ru/blogs/200419/50148/