The problem with too much water in the garden is familiar to many gardeners. Low location areas, marshland and clogged gutters lead to long-term moisture stagnation. the problem is particularly acute during the rains, when the garden literally transformed into a swamp.
To grow the crop plants in conditions of constant humidity is almost impossible. Water washes away from the land all the nutrients and trace elements, the soil loses its fertility and becomes a dead substrate. In addition, the absence of a consistent air circulation leads to the fact that the plant roots begin to rot.
Who should decide this issue
In an amicable way, the problem with long-term stagnation of water should be addressed at the level of gardening. Only in this case it is possible to fully drain the lot and avoid a large accumulation of moisture. Everything is done through a system of large and small drains, which are located between the sections and along the roads.
However, not every gardening will take up the creation and ongoing maintenance (Cleaning, deepening, expansion) a drainage system. Therefore, the problem must be solved on the spot.
How to make a drainage area itself
Creating a full drainage system on an individual project should not just a lot, but a lot of money. Some materials, excluding work can cost more than 50 thousand. rubles. For me, as for many gardeners, it's very heavy sum.
Therefore, it is necessary to do the drainage improvised. One of the most common methods involves the use of plastic bottles.
We do drainage from plastic bottles
Creation begins with a drainage plan for the lowest places periodically collects rainwater.
After that, we need to devise a system of waterways that will take excess water off-site. In fact, draw a plan for a "channel" through which water will go from the garden.
The essence of the system lies in the fact that we replace the drainage device is typically purchased bottles. Everything is done in several steps:
- Dig a trench depth desired. Usually, Depth determined by dense layers of soil or the water level in the ditch, which will go away moisture. Do not forget that the ditch should be at a slight slope, otherwise it will start to stagnate moisture;
- At the bottom of the moat in several rows laid empty plastic bottles. Make sure that the packaging is closed. Otherwise, over time, a bottle somnet and bandwidth will decrease;
- Bottles fall asleep sand layer thickness of 5 cm. and lightly tamped. Sand can be used any type and faction, but it is better if it is large;
- We fall asleep trench with bottles fertile soil and the ground tamped;
- Align the territory.
Our drainage ditch ready. The water will fall into such a system along the entire length of the underground pit, which will effectively drain the surrounding area.
Top can be arranged on our system beds, sitting area, or track. One year later, on the work carried out will be over. The territory is equalized and overgrown grass.
Plastic bottles do not decompose and do not decompose, so this method is completely eco-friendly and harmless to plants. I would advise you to sketch the whole system of underground trenches in case if you want to dig it.
Such a simple drainage will allow water to quickly leave the area, eliminate the long stagnation of moisture and improve air exchange of the soil.
I would be glad if my article was useful to you. Put the "Thumbs Up" and subscribe to a channel. Thanks!