Elementary and reliable way to make a handle for the knife, if the former is out of order

  • Dec 24, 2019
Elementary and reliable way to make a handle for the knife, if the former is out of order.
Elementary and reliable way to make a handle for the knife, if the former is out of order.

The harsh reality is that the knife handle can fail at the crucial moment. It does not matter that led to its scrapping - mechanical load and workmanship. Out of the situation just two - to make a new pen, or just throw the tool. If the latter is for the host is not an option, then you can try to solve the problem with their own hands and improvised materials.

Take the rope. / Photo: youtube.com.
Take the rope. / Photo: youtube.com.

What is needed: 2.5 meters thick rope, a piece of cardboard, tape, lighter, scissors

IMPORTANT: Before you get to work with a pen, you need to best protect the blade. To do this, first remove the instrument from its case, and then close the blade cardboard thoroughly strapped him to the knife by means of adhesive tape.

Nothing complicated. / Photo: youtube.com.
Nothing complicated. / Photo: youtube.com.

Take the cooked rope and bend it in half. Then we start with its top of the handle. Tie a knot. Now we press the rope to the place where the overlap will be done. It is important to ensure that in the process of the rope is not sprawling. To do this, you need to constantly correct the rope structure.


We begin to knit. / Photo: youtube.com.
We begin to knit. / Photo: youtube.com.

Once the first node is ready to handle one of the parties, is below the second. For each procedure of tying unit is the same. After the formation of a new node, the rope must be pulled as tight as possible and corrected. Formation node continues as long as the rope will not cover an entire handle. For this reason, it should be taken with some reserve.

READ ALSO:How fast to thread a needle, if your hands are shaking and his eyes fed

Constantly tightens. / Photo: youtube.com.
Constantly tightens. / Photo: youtube.com.

After wicker handle reaches the end, it should be unnecessary to trim ends of the rope leaving approximately 5 mm on each side. Feathered ends mandatory cauterizing and melt. Care must be taken to ensure that the rope is not caught fire. While the polymer does not have time to cool down, you need to have time to squeeze it to the last round of the finished winding.

It turns out like this. / Photo: youtube.com.
It turns out like this. / Photo: youtube.com.

>>>>Ideas for life | NOVATE.RU<<<

Continuing the theme, read about 13 reasons why the wise housewives do not throw an old toothbrush and not only.
A source:
https://novate.ru/blogs/200819/51459/