During the cleaning of the site, at the onset of spring, gardeners often find rotten or dry trees that need to be cut down urgently. But without a properly drawn up work plan, there is a high probability of being seriously injured or damaging the building. We bring to your attention the instruction, which will describe how to cut down a tree and knock it down in the direction you need.
I recommend reading: When to prune grapes: tips for beginners
Estimation of the scope of work
At the very beginning, you need to correctly assess your strength, that is, can you cut a tree alone or you need help. Please note that the tree needs not only to be cut down, it also needs to be knocked down in the right direction, so as not to affect the power lines and nearby buildings. In the absence of the necessary skills, it is better to use the services of specialists.
Timing for felling
The felling of trees is not carried out in rainy and windy weather. This is due to the fact that with a strong wind it will be difficult to calculate the trajectory of the fall, and if the wind is almost not felt below, then at the level of the crown it can be quite strong. Therefore, before starting work, pay attention to the crown, if it sways, then it is better to postpone the procedure until the wind dies down. The same rules apply for rainy weather. In heavy rainfall, tools will simply slip out of your hands, not to mention wet, unstable ground under your feet.
Site preparation
The radius of the work area can be determined by the height of the tree, you need to add a few meters to it, since when the trunk falls, it will bounce off the stump. The entire surrounding area should be cleared of unnecessary items, equipment and debris.
Preparing inventory
To work you need an ax and a saw. You also need to think about your own equipment. If a chainsaw is to be used, the eyes are covered with protective goggles. Choose clothing that reduces the likelihood of injury, such as protective gloves, a hard hat or hat, and special shoes.
Tying the trunk with ropes
The top of the trunk must be tied with ropes. With their help, it will be easier to set the trajectory of the fall of the tree.
How to make a guide hem
A wedge-shaped guide hem is made on the tree trunk from the side where it will fall. In work, it is most convenient to use an ax. In this case, the lower cut goes parallel to the ground, the upper one at an angle of 45 degrees to it.
Making a felling cut
It is made with a saw slightly above the lower cut of the undercut to the middle of the trunk, while trying not to touch the core. Its fibers will hold the tree until the start of felling.
Tree felling
When everything is ready, you can start cutting down the tree. Call in helpers to tie the ropes around the trunk and pull it into the expected fall zone.
Territory cleaning
First of all, the tree needs to be cut for firewood. Next, decide what to do with the hemp. It can be uprooted or turned into a garden trunk or chair. The remaining branches, pieces of bark, leaves are collected in one heap and removed or set on fire.
By adhering to our instructions, you can easily and quickly get rid of old, dry wood on your territory. Doing this alone is not recommended, call a few friends for help to make your job easier.
Do you know how to cut a tree correctly?
Original articleand many other materials, you can find on ourwebsite.
Read also: Egg shells are a treasure for the garden: how to use them